الصورة الكبيرة
Closed type sampler-Powder particle sampler-China mechanical equipment (Zhengzhou) Co., Ltd.
China mechanical equipment (Zhengzhou) Co., Ltd. to provide you with a large number of Zhengzhou can be closed sampler, powder particle sampler|, powder particle sampler factory, at the same time you can provided free of charge a complete sampling solutions, to meet your needs, product application scope widely, such as can not meet your specific requirements, can also according to your specific requirements custom-made
model：BTZ-F
Closed type sampler with6679-2003 GB/TGeneral rules for the sampling of solid chemical products, applicable to: powder, small particles, small crystals and other materials are less than the diameter of5MMFor diameter greater than5MMSolid sampling probe capable of special processing) solid sampling of chemical products. Material: stainless steel, diameter25MMLength800MMSlot.Nineteen×680MM.
Another: a closed sampling probe tip closed sampling probe of bottle type sampling probe can be Click to view product information
Closed type sampler probe characteristics:
OneMaterialThree hundred and fourStainless steel, no pollution to the sample, widely used in pharmaceutical, food and other industries.
TwoThe sampling probe. The inner wall and the outer wall polishing treatment, can prevent the contamination of the sample and easier to clean.
ThreeThe sampling probe. All parts can be disassembled, easy to clean, can prevent the remaining bacteria and pollutants.
Product selection:For loose solid sample sampling level: end closed sampler, an end opening of the sampler, the window is closed sampler. If the vertical sampling the sampling probe inserted into the material along the diagonal direction.
For solid sample thick can choose: universal sampling probe. The unique design of the universal type sampling probe, both horizontal or vertical sampling for sampling.
Closed type sampler method using probe:
OneBefore use, should check whether the sampling probe cleaning.
TwoThe sampling probe inserted into the notch downward along a certain angle material, reach the designated depth after rotation2-3Time, careful sampling probe pulled back, pay attention to withdraw when sampling probe slot should be upward, and the sampling probe material into the sample container.
ThreeIf the material is not loose, the discharge from the sampling probe inserted into the rear end of the push rod material smoothly into the sample container.
FourThe sampling probe clean, complete sampling.
